CREATING

3 points are requested for the macro :

1.    Point 1 is at the first hole center

2.    Point 2 is at the second hole center

3.    Point 3 is used to define the working plane

The working plane may be below the upper plate (plane position 1) of in the bracing axis (plane position 0) or above the lower plate (plane position -1)

If plate quantity is 0, 2 plates are created

If plate quantity is -1, only the lower plate is created

If plate quantity is +1, only the upper plate is created.

If the center gap is 0, the value si automatically set to 140 for a round shape of 30 mm diameter. For all the other diameters, the gap is set to 60 mm

If the hole diameter is created, no hole is created.